HP 3PAR Application Software Suite for Microsoft Hyper-V - Manual (Page 75)

Table 38 Add-RemoteStoreServ parameters (continued)
Description Optional/Required Parameter
The user name of the Remote RMH
Server. Optional -RemoteRmhServerUsername
The password of the Remote RMH
Server. Optional -RemoteRmhServerPassword
All the common parameters across the
commands. Optional CommonParameters
Add-StoreServ
Add-StoreServ is used for each HP 3PAR StoreServ credentials.
•
HP 3PAR StoreServ credentials are associated to a specific Microsoft Hyper-V
•
This command is only required to initially set up credentials. The command is persisted by
RMH Server until the user removes it.
•
The user can Add/Remove/Update HP 3PAR StoreServ credentials at any time during the
session
Preconditions
•
The user must first login with Login-Rmh.
•
HP 3PAR StoreServ name must not already exist for specified Microsoft Hyper-V
Syntax
Any optional parameters require square brackets [ ] around them.
Add-StoreServ -RmhServerName <RmhServerName> -HypervName <HypervName>
-StoreServName <StoreServName> -StoreServUsername <StoreServUsername>
-StoreServPassword <StoreServPassword> [-Verbose]
Table 39 Add-StoreServ parameters
Description Optional/Required Parameter
Host name of the RMH Server. This is
FQDN or IP address. Required -RmhServerName
This is FQDN or IP address. Synonyms
are supported. The localhost is not
supported. Required -HypervName
This is FQDN or IP address, etc.
Synonyms for HP 3PAR StoreServ are
supported. Required -StoreServName
Note, if not provided, a dialog box will
pop up asking for credentials. Required -StoreServUsername
Note, if not provided, a dialog box will
pop up asking for credentials. Required -StoreServPassword
Displays progress messages Optional -Verbose
Add-StoreServ 75