HP Brocade 8Gb SAN Switch for HP BladeSystem c-Class - Manual (Page 48)

the voltage and current rating marked on the product. In addition, the diameter of the wire must
be a minimum of 1.00 mm
2
or 18 AWG, and the length of the cord must be between 1.8 m (6 ft)
and 3.6 m (12 ft). If you have questions about the type of power cord to use, contact an HP
authorized service provider.
NOTE: Route power cords so that they will not be walked on and cannot be pinched by items
placed upon or against them. Pay particular attention to the plug, electrical outlet, and the point
where the cords exit from the product.
Japanese power cord notice
48 Regulatory compliance notices