HP EML E-series Tape Libraries - Manual (Page 46)

Figure 43 Indicators on an LTO5 and LTO6 tape drive
Table 14 Indicators on an LTO5 or later tape drive
Function Control/indicator Index No.
When lit (yellow), indicates that initialization is in progress,
the library robotics controller software has detected a failure FAULT 1
that requires the replacement of the tape drive assembly,
or a hot swap can occur.
When not lit, indicates normal operation.
Beacon. ID 2
When flashing (green), indicates that the drive is reading
or writing encrypted data. ENCRYPTION STATUS 3
When flashing, indicates activity across the Ethernet port. MANAGEMENT ACTIVE 4
When lit (orange), indicates the Ethernet port is connected. MANAGEMENT SIGNAL 5
When lit (green), indicates link activity on FC port A. FC A 6
When lit (green), indicates link activity on FC port B. FC B 7
Switch for the internal network
Figure 44 Indicators on the switch for the internal network
Table 15 Indicators on the switch for the internal network
Function Control/indicator Index
No.
On--The switch is receiving power. Off--The switch is not receiving power. Power (green) 1
FDx--Indicates that the port Mode LEDs are displaying whether the ports are
operating in full-duplex. Speed--Indicates that the port Mode LEDs are displaying
the operating speed. LED Mode Select (2 green
LEDs) 2
46 Using the library