HP ProLiant SL390s G7 Server - Manual (Page 28)

Hardware options installation 28
4. Install drives on the quick release carriers to the system tray.
5. Install drive into the front of the system tray:
a. Insert the drive into the chassis.
b. Rotate the tray handle to lock the power connector.
6. Install the server into the chassis (" Installing the server into the chassis " on page 23 ).
7. Connect the peripheral devices to the server.
8. Power up the server (" Powering up and configuring the server " on page 25 ).
NOTE: LFF hard drives are illustrated in the figures in this guide. SFF hard drives are also
supported.
Removing a drive
CAUTION: For proper cooling, do not operate the server without the access panel, baffles,
expansion slot covers, or blanks installed. If the server supports hot-plug components, minimize
the amount of time the access panel is open.
To remove the component:
1. Back up all data on the hard drive.
2. Power down the server (on page 18 ).