HP XC System 3.x Software - Manual (Page 114)

10.14 LSF-HPC Equivalents of SLURM srun Options
Table 10-3 describes the srun options and lists their LSF-HPC equivalents.
Table 10-3 LSF-HPC Equivalents of SLURM srun Options
LSF-HPC Equivalent Description srun Option
bsub -n num Number of processes (tasks) to run. -n
--ntasks=ntasks
HP XC does not provide this option because
the meaning of this option can be covered by
bsub -n
and mincpus=n.
Specifies the number of cores per task.
Min processors per node =
MAX(ncpus, mincpus) -c
--processors-per-task=ntasks
-ext "SLURM[nodes=minmax]"
where minmax is min[-max]
Specifies the minimum and, optionally,
maximum number of nodes allocated
to job. The job allocation will contain
at least the minimum number of nodes. -N
--nodes=min[-max]
-ext "SLURM[mincpus=n]" Specifies the minimum number of
cores per node. Min processors per
node = MAX(-c ncpus, --mincpus=n).
Default value is 1. --mincpus=n
-ext "SLURM[mem=MB]" Specifies a minimum amount of real
memory of each node. By default, job
does not require -ext. --mem=MB
-ext "SLURM[tmp=MB]" Specifies a minimum amount of
temporary disk space of each node. By
default, job does not require -ext. --tmp=MB
-ext "SLURM[constraint=list]" Specifies a list of constraints. The list
may include multiple features
separated by the & character (meaning
ANDed) or the | (meaning ORed). By
default, job does not require -ext. -C
--constraint=list
-ext
"SLURM[nodelist=node1,...nodeN]" Requests a specific list of nodes. The
job will at least contain these nodes.
The list may be specified as a
comma-separated list of nodes, or a
range of nodes. By default, job does
not require -ext. -w
--nodelist=node1,...nodeN
-ext
"SLURM[exclude=node1,...nodeN]" Requests that a specific list of hosts be
excluded in the resource allocated to
this job. By default, job does not
require. -x
--exclude=node1,...nodeN
You cannot use this option. The lsf partition
is the only one provided. Requests resources from partition
partition
.
-p
--partition=partition
-ext "SLURM[contiguous=yes]" Requests a contiguous range of nodes.
By default, job does not require
contiguous nodes. --contiguous
bsub -o output_file Specifies the mode for stdout
redirection. -o
--output=file_name
You can use this option when launching
parallel tasks. Specify the mode for stdout
redirection. -o
--output=none,tasked
bsub -i input_file Specify how stdin is to be redirected. -i
--input=file_name
114 Using LSF-HPC