HP OneView for Microsoft System Center User Manual
HP Software
Advertising
Table of contents
Document Outline
- HP Virtual Connect Management Pack (v 3.1) for Microsoft System Center User Guide
- Contents
- 1 Overview
- 2 Using the Virtual Connect Management Pack with Operations Manager
- 3 More about the Virtual Connect Management Pack
- 4 Virtual Connect NT events
- 5 Troubleshooting
- Introduction
- Authoring issues
- Operational and usage issues
- Researching state monitoring
- Expected associated classes are not displaying in the Domain State or Health Collection views
- Event view and Performance view are empty
- Tasks not launching from the Health Explorer Properties or Product Knowledge pages
- The Group Diagram view displays initials of folder names
- Active Alert view displays one alert although multiple device state changes occurred
- Management console displays the same domain multiple times
- Management console does not display alerts in the Active Alert view when opened from the Domain State view
- Health Explorer does not display Knowledge Information for computers and certain Windows components
- HP Custom Data Manager cannot be used in the HP Virtual Connect Management Pack
- Health rollup to VC Domain does not bring the worst case health status from underlying health components
- If a VC FC Uplink becomes unpopulated its health status is set to “Warning” instead of “Healthy”, irrespective of Flex-Fabric and Ethernet uplinks
- When an uplink status restores from Error to Normal, Event ID 7500 or 7800 is raised in VC Active Alerts view
- Alerts show the IP of the module rather than the overall Primary IP, or statically configured domain IP
- When a static domain IP is configured, any alert raised from a Primary VC module will have the source IP of the domain IP instead of the Primary module IP
- When an Ethernet/Flex Fabric/FC module's power is switched off its Uplink status shows “Healthy”, but the Port status property shows “Not Linked” in the Ethernet/Flex Fabric/FC Uplink Ports State view
- When link status is ‘Unpopulated,’ port health status is shown as ‘Warning’ for Ethernet & FlexFabric Uplink Ports
- Managing a VC domain via any VCEM web console
- VC event IDs 7500, 7800 doesn’t show VC uplink port as per VCM
- Event ID 7800 critical alert is not generated
- Both event IDs 7500 and 7800 are raised when an Ethernet or FC uplink is disconnected from VC Flex Fabric Module
- Device Monitor (DMC and DMS) operational and usage issues
- 6 Support and other resources
- 7 Documentation feedback
- Index