HP Designjet T610 Printer series - Manual (Page 33)

To complete the change, you must close and reopen your Web browser.
Change the sleep mode setting
If the printer is left switched on but unused for a certain period of time, it goes automatically into sleep
mode to save power. To change the time the printer waits before it goes into sleep mode, press the
Menu key to return to the main menu and select the Setup menu icon , then Front panel
options > Sleep mode wait time. Highlight the wait time you want and then press the OK key. You can
set the time to 30, 60, 120, 150, 180, 210, or 240 minutes.
Turn the buzzer on and off
To turn the printer's buzzer on or off, press the Menu key to return to the main menu and select the
Setup menu icon , then Front panel options > Enable buzzer, and highlight on or off and press
the OK key. By default, the buzzer is set to on.
Change the front-panel display contrast
To change the contrast of the front-panel display, select the Setup menu icon , then Front panel
options > Select display contrast, and enter a value using the Up or Down key. Press the OK key to
set the value. The default contrast is set to 50.
Change the units of measurement
To change the units of measurement in the front-panel display, select the Setup menu icon ,
then Front panel options > Select units, and select English or Metric. By default the units are set to
metric.
Configure network settings
To configure the same network settings from the front panel, press the Menu key to go to the main menu
and select the Connectivity menu icon . You can view and configure the following network settings.
● USB: view information about the USB connection
● JetDirect EIO: view information, configure, and reset the JetDirect connection
● Advanced > Select I/O timeout: specify the number of seconds that an idle connection is allowed
to remain open, 270 is the default value, if set to zero, the timeout is disabled
● Advanced > Allow SNMP: specify whether SNMP is permitted
● Advanced > Embedded Web Server > Allow EWS: specify whether the Embedded Web Server
is enabled
● Advanced > Web Services > Printer Utility software: view the Printer Utility software settings
● Advanced > Web Services > Color and paper management: view the color and paper
management settings
ENWW Change the sleep mode setting 23
Perso
n
al settings