HP D6000 Disk Enclosure User Manual
Page 22
Advertising
Setup 22
2.
To remove the I/O blank, release the I/O blank handle, pull the I/O blank handle down until it ejects
the I/O blank, and then remove the I/O blank from the enclosure.
3.
To install the I/O module, insert the I/O module into the enclosure and push the I/O module handle up.
Be sure the I/O module is seated fully, and the I/O module handle is in the locked position.
The installation installation is complete.
To install the second I/O module in the other enclosure drawer, repeat the procedure.
CAUTION:
For best cooling practices, do not operate the enclosure for extended periods with
more than one component or blank removed. When removing an active component, replace it
with a blank.
Advertising