American Fibertek Commander C10e/C10e-I/C10p/C10p-I - Manual (Page 39)

39
IP Settings
Default IP Settings
Commander’s default settings are displayed to the
right. DHCP is set to off in the default settings and the
default HTTP port is 80.
IP Address: 192.168.10.11
Subnet mask: 255.25.255.0
Gateway: 192.168.1.1
HTTP Port
This is the port used to access these setup screens via a
web browser. This setting is restricted to certain ports as
displayed on screen.
DHCP
When DHCP is enabled Commander will report any changes in its IP Address to the email address
entered in the Global Settings.
DNS
A DNS resolver address is required for SMTP (email) to function. Select Enable and enter at least one
DNS server address.
Port Communications
Port communications is controlled by the switch. See Switch Flow under Switch Setup.
Alert Console IP Address:Port
The Alert Console allows you to program an IP address and port to receive alerts responses to alarms
and warnings. The receiving computer must allow these alerts to be received. Up to four addresses and
ports may be entered separated by a space. Use this setting to specify your Pilot VMS server. The
message box below will indicate when a connection to the event server has been established.
Network Settings: Saving your settings
Clicking the Save button will result in a pop up asking
you to confirm your settings. Click OK to confirm.
Click Cancel to return to the previous screen.
Remember to make a note of your new IP Address.
Network Settings: Settings Accepted
When Commander has successfully accepted your
changes it will issue a pop up. Click OK to continue
set up.