ididit Universal Steering Column: Universal Tilt - Manual (Page 3)

7/8”–1” engagement). Use a marker to make a mark through hole in the
joint. Remove the joint. Using a 5/16 inch drill bit, spot the shaft where
the setscrew will seat. Re-install the joint and install setscrew and jam
nut. (Note: all joint manufacturers recommend using a thread-locking
compound on setscrew and nut).
KNOB & LEVER INSTALLATION:
Tilt Lever:
After removing all items from the package, screw
the knobs onto the levers. The tilt lever is installed
on the left side of the column in the threaded hole
closest to the dash. We recommend using Locktite.
Turn Signal Lever:
The turn signal lever is inserted into the hole
closest to the top of the column. With the steering
wheel and adaptor removed, look down from the
top of the column and you’ll see two holes on
the turn signal switch. One is D shaped and the
other is round. With the lever in place, insert the
provided screw into the round hole. Use a #2
Phillips screw driver to tighten the screw tightly.
Emergency Flasher Knob:
The emergency flasher is threaded into the hole
located on the right side of the column. You will
notice the nylon switch that the flasher screws into
is flush with the outer surface when in the OFF
position. It is easy to accidently turn the flashers
ON while installing, which could lead to problems
later. Check to make sure that the knob is in the OFF
(out), position before continuing.
If Column Shift Application:
Place column shift knob onto the shift lever. Once
the lever is in place, use setscrew (provided) and
adjust knob so set screw is pointing away from you,
tighten setscrew. Do not remove the upper shift lever
for any reason! The tension spring will pop out and
it is very difficult to re-install.
2
Thank you for purchasing an ididit steering column!