ididit Cable Shift Linkage Kit: GM Column to GM Transmission - Manual (Page 14)

13
Warnings!!! Please read!!!
You will need at least 2” of clearance between the firewall and
lower shift lever for this product to function correctly.
Melted Cables: If your cable is too close to your exhaust it will
melt or become brittle. If this is the case you will need to make a
heat shield. Do not wrap the cable as this retains heat. Heat will
destroy the cable.
Kinked Cables: Do not kink the cable anywhere along its length. If
the cable has a kink it will lock up. The cable should be kept straight
for 2” on each end where it leaves the brass. Either of the above
could damage the cable, shifter, and/or transmission in one shift.
Cable Adjustment: If you do not adjust the cable correctly you
could damage the cable, shifter and/or transmission. Put the trans
in Low gear and the shifter in Low gear, set the swivel so it slides in
and out of the correct hole freely. Then move the transmission and
shifter to Park (all the way the other way). Rotate the cable swivel
until it slips in and out of the hole freely. Now go back and forth
between Park and Low gear and fine tune the adjustment. See in-
structions for further detail.
If you are having problems with your installation
please contact us at:
PH: (517) 424-0577 or email: [email protected]
M-F 8:30a-5:30p EST
Sat. 10:00a-2:00p
www.ididitinc.com