JELD-WEN SVC001 Builders Vinyl Sliding Patio Door Handing Reversal - Manual (Page 2)

SERVICE SUPPLEMENT
Builders Vinyl Sliding Patio Door Handing Reversal (SVC001)
2
5. Pry both anti-
lifts from header
with flat head
screwdriver.
6. Flip frame (top to
bottom).
7. Gently pry out the
frame dust plugs
in both ends of the
sill with flat head
screwdriver and
install these in the
corresponding holes
in the head jamb.
SwITCh ROLLERS ANd LOCk
1. Lay the panel on a flat padded surface.
2. Remove attachment screw (top screw on each roller) from the roller
on each end of the panel and remove.
3. At other end of panel, pry the dust plugs from roller screw holes with
flat head screwdriver. Install both rollers on the opposite end of the
panel.
4. At opposite end, install dust plugs (two at each end with 1/2" in large
holes and 1/4" in small holes) into previous roller screw holes.
5. If the handle is pre-
installed, remove the
2" machine screws
from interior handle
set and remove both
handles and handle
lever.
Note: Step 6 must be
performed with the
panel in a horizontal
position to keep the
lock reinforcement
bar from falling down
inside the panel.
6. Pull hook out to
locked position with fingers or pliers. Maintain grip on latch hook to
keep lock from falling inside stile.
7. Remove both phillips screws to remove lock.
8. Remove and turn lock over and reinstall with hook facing the
opposite direction.
9. Reinstall the handle lever on the interior and then both handles.
REMOVE SCREEN - CONTINUEd
Note: do not damage
track when removing;
this may result in poor
screen operation.
3. Grip one end of the
screen track with
pliers and lift up
carefully to remove.
REMOVE OPERATINg PANEL
1. Completely open operating panel to clear anti-lifts in the header.
2. Roller adjustment
screws are at
both bottom ends
of the panel.
With a phillips
screwdriver, turn
the bottom screw
counterclockwise to
retract rollers and
lower the panel.
3. From the interior,
lift panel bottom up
and over sill track
and pull inward (if
needed, insert a
large putty knife
between the track
and the rollers to
help lift over the
track).
Note: do not damage
track or metal track cover when removing track; this may result in poor
operation.
4. Grip one end of the
operating panel track
with pliers and lift up
carefully to remove.
Attachment
screw
Adjustment
screw
Operating
panel track
Anti-lift
block
Dust
plug
Lock
hook
Handle
lever
Interior
handle
Exterior
handle
Attachment
screws