Lokar TL-1911 Chromed Billet Oval LED Taillights - Manual

Building American Quality… With A Lifetime Warranty!
Step 5: Install the supplied 8-32 set screws through the retain-
ing brackets and hand tighten against the oval washer.
See Photo 5
Step 6: Using a cross pattern, gently tighten the 8-32 set screws
until the taillight has been drawn to the body panel.
Warning: Do not over tighten to avoid damage to paint.
Stop! Please read all installation instructions before
beginning installation. Call Lokar for any questions or
uncertainties during installation.
WARNING: Disconnect battery before beginning instal-
lation. Make sure vehicle is in Park. Be sure that the
vehicle’s parking brake is set and scotched to avoid
movement of the vehicle.
IMpoRtANt: Before beginning any cutting, be sure
there is adequate clearance behind the body panel for
the installation of the taillight.
Chromed Billet Oval LED Taillights Installation
NOTE: The taillight is shipped fully assembled for Quality
Control. DO NOT REmOvE the back plate as parts may
be lost.
Step 1: Using the provided template, layout and cut an
opening in the desired location. See Photo 1
Note: It is crucial that the opening not be oversized to
ensure proper fit.
Step 2: Insert the taillight carefully through the opening.
See Photo 2
Step 3: Install the oval washer around the taillight.
See Photo 3
Step 4: Install the two retaining brackets using the supplied
6-32 socket head allen bolts. See Photo 4
10924 Murdock Dr. • Knoxville, TN 37932
TOLL FREE 1-877-469-7440 • (865) 966-2269 • FAX (865) 671-1999 • [email protected] • www.lokar.com
Chromed Billet Oval LED Taillights Installation Instructions
Part # TL-1910 and TL-1911
Chromed Billet Oval LED Taillights Installation Instructions
Part # TL-1910 and TL-1911
Step 7: Install supplied 8-32 jam nuts onto set screws and
tighten. See Photo 6
Step 8: Wire taillights into 12 volt system.
Note: Due to low current draw of LED lights,
some vehicles may require a “No Load Flasher”.
Available from Lokar, Part No. TL-1912
GREEN = Brake wire (turn signals controlled by turn signal switch)
YELLoW = Taillight wire (running lights)
BLACK = Connect to a GOOD chassis ground
Photo 1 Photo 2 Photo 3
Photo 4 Photo 5 Photo 6
© 2007 Lokar, Inc. Rev. 5/15/08
™