Lokar Billet Drive-By-Wire Throttle Pedal - Manual

Building American Quality… With A Lifetime Warranty!
General Installation Notes:
Please read these instructions completely before beginning the installation. If
you have any questions please call.
Before beginning the installation, disconnect the negative battery cable and
use wheel chocks to block the vehicle's wheels.
Make sure the engine, transmission, and frame are properly grounded.
Note: DO NOT remove the sensor or disassemble the electronic throttle control module! Lokar's
Billet Drive-By-Wire pedals are pre-programmed to match your application. If you remove the
sensor or disassemble the electronic throttle control module you will void your warranty!
Refer to Fig. 1 for the component names.
Mounting the Lokar Billet Drive-By-Wire Pedal Assembly
Step 1: Install the splined bushing into the lever on the electronic throttle control module
so that half of the splined bushing is protruding to the right. Slide the pedal arm
onto the splined bushing. Install an aluminum end washer and 1/4"-20 x 3/8"
flathead bolt onto each end of the splined bushing. Fig. 2 and Fig. 3
Step 2: Determine your mounting location. Mounting locations will vary, and the Lokar
pedal can be mounted in any position. It may be necessary to try it with the
pedal arm assembled in several different positions on the electronic throttle
control module, in order to find the best fit. Some applications may require that
the installer create a custom mounting bracket. Once you have decided on the
mounting location, trace around the bottom edge and up both sides of the
electronic throttle control module to mark the position on the firewall.
Step 3: There are two mounting holes in the electronic throttle control module. The center
of the lower mounting hole is approximately 31/32" above the bottom edge of
the electronic throttle control module, and the mounting holes are 2-1/4" apart
center-to-center. Fig. 4
Measure and mark the location of the mounting holes on your firewall. Center
punch the marks and drill two 3/8" diameter holes in the firewall.
Step 4: Install the assembled pedal and electronic throttle control module onto the firewall
using two 3/8"-24 bolts of your choice (not included). NOTE: The bolts should be
no more than 1/2" longer than the thickness of your mounting surface to prevent
them from bottoming out. Using bolts that are too long can damage the electronic
throttle control module.
Once the assembly is mounted to the firewall, the angle of the pedal arm can be
adjusted. Remove the 1/4"-20 x 3/8" flathead bolt and aluminum end washer from
the right side of the pedal arm. Slide the pedal arm off of the splined bushing and
index the throttle pedal arm to the desired position. Fig. 5 Install the aluminum
end washer and 1/4"-20 x 3/8" flathead bolt back into the pedal arm and tighten.
TOLL FREE 1-877-469-7440 • [email protected] • www.lokar.com
®
Billet Drive-By-Wire Throttle Pedal
Installation Instructions
Billet Drive-By-Wire Throttle Pedal
Installation Instructions
INS0156 Rev. 07/22/14 Page 1 © 2014 Lokar, Inc.
Fig. 1
Pigtail
(Flying Lead Type Shown)
Butt Connectors
Pedal Arm
1/4"-20 x 3/8"
Flathead Bolt
1/4"-20 x 3/8"
Flathead Bolt
Lokar Accelerator
Pedal Position
Sensor (APPS)
Electronic Throttle
Control Module
Splined
Bushing
Lever
Aluminum End
Washer
Aluminum
End Washer