Vaisala viewLinc-4.1-M211518 - Manual (Page 23)

Installing viewLinc
viewLinc 4.1 Administrator Guide 11
Method 2: Using Digi Devices
The following procedure shows how to use Digi devices to
connect your Vaisala Veriteq devices to the network.
Attaching Main Hardware
1
Connect your Vaisala Veriteq device to a Digi device
using a Vaisala Veriteq cable.
2
Connect your Digi device to power supply and Ethernet
outlet.
Note:
These instructions focus on the Digi One SP. For
other Digi models, see www.vaisala.com/life-
science-hitech.
Installing Digi Drivers
This section covers installing the drivers for Digi devices to
connect Vaisala Veriteq devices or Vaisala 300 Series
Transmitters to the network using an Ethernet connection.
Repeat all of these steps for each Digi device you’ll use.
Discovering the Digi Device
1
Obtain a reserved (recommended) or static IP address
for your Digi device from your IT department. If your
networking policy requires you to reserve IP addresses
using DHCP, see www.vaisala.com/lifescience-hitech for
instructions.
Figure 2: Overview of viewLinc system using Digi devices