VariZoom VZSNAPCRANE12-100 - Manual (Page 5)

5
Extension Section 1
If using the Crane in the 2 shortest modes, you can skip this section
and go to “Front Section.”
Next you will need to attach extension section 1 to the pivot section.
Loosen the dovetail lock thumbscrew just enough to allow the two
sections to engage.
Slide extension section 1 into place, tighten the dovetail lock
screw, and snap down the locking latch. (latch tension is
adjustable w/ flat screwdriver)
FRONT SECTION
Next, attach the front section (printed with
“VariZoom”) to your crane. Loosen the dovetail
lock screw just enough to allow the two sections
to engage.
Slide the front section into place, tighten the
dovetail lock screw, and engage the latch. Now
pull the pins out of the camera platform and
attach it to the front section. Attach it to the front
section with the large pin and leave the small pin
hanging.