Videoswitch Vi-POSCON - Manual (Page 15)

Videoswitch 15 Pos601a.doc
Vi-POSCON Installation Guide
Note: If you are installing the 40-column dot-matrix Epson TM-U200D printer option, you must set the
4-position DIP switch located beneath the inspection plate on the bottom of the printer. Set the switch
to the following positions: 1=OFF, 2=OFF, 3=OFF, and 4=ON.
Note: If you are installing the 40-column Epson TM-T88 Thermal printer option, you must set the 8-
position DIP switches located beneath the inspection plate on the bottom of the printer. Set switch
DSW1 to the following positions: 1-6 and 8=OFF, and 7=ON (default). Set switch DSW2 to the
following positions: 1-8=OFF (default).
Note: There are no changeable option settings for the 80-column Epson LX-300 printer. However,
you can use the control panel on the 80-column Epson LX-300+ printer to change its default settings
(refer to the LX-300+ User's Guide for instructions). You may have to change the default paper length;
all other options can remain at their default settings.
For instructions on alarm connections, see the documentation supplied for the DVR.
For instructions on programming the DVR, see the documentation supplied with the unit.
You have completed the Vi-POSCON hardware installation. Continue with the section titled Power-
Up Sequence (page 14).