Dake Model HV 200 - Hydraulic - Manual (Page 6)

Dake Tube Bender manual 08212009 6
Take your follower plate and set your follower on the center of it and
lock it in place with the set screw on the follower. Take your follower
plate assembly and set it on the rollers in the frame of your tube bender.
Next, you will need to
access the hydraulic line.
Remove the four allen
head screws on the right
side panel. You should be
facing the side with no
measurement sticker.
When installing the hydraulic line make sure the hydraulic line travels through the welded ring inside the
frame. When the hydraulic line is installed reinstall the cover using the allen button head screws to hold it
in place.
Be sure the hydraulic line is tight.
Using the U-shaped hook and hook pin,
install as shown above.
Remove this side
to access the
hydraulic line.
Welded ring
Hook
Hook pin
There is a set screw on the end
of the follower bar to holde the
die and follwer bar together. Be
sure this set screw is tight.