Asus P4SDX - Manual (Page 27)

ASUS P4SDX motherboard user guide 1-17
1. Floppy disk drive connector (34-1 pin FLOPPY)
This connector supports the provided floppy drive ribbon cable. After
connecting one end to the motherboard, connect the other end to the floppy
drive. (Pin 5 is removed to prevent incorrect insertion when using ribbon cables
with pin 5 plug).
2. IDE connectors (40-1 pin PRI_IDE, SEC_IDE)
This connector supports the provided UltraDMA133/100/66 IDE hard disk ribbon
cable. Connect the cable’s blue connector to the primary (recommended) or
secondary IDE connector, then connect the gray connector to the
UltraDMA133/100/66 slave device (hard disk drive) and the black connector to
the UltraDMA133/100/66 master device. It is recommended that you connect
non-UltraDMA133/100/66 devices to the secondary IDE connector. If you install
two hard disks, you must configure the second drive as a slave device by setting
its jumper accordingly. Refer to the hard disk documentation for the jumper
settings. BIOS supports specific device bootup. If you have more than two
UltraDMA133/100/66 devices, purchase another UltraDMA133/100/66 cable.
You may configure two hard disks to be both master devices with two ribbon
cables – one for the primary IDE connector and another for the secondary IDE
connector.
1.12 Connectors
This section describes and illustrates the internal connectors on the motherboard.
P4SDX
®
NOTE: Orient the red markings on
the floppy ribbon cable to PIN 1.
P4SDX Floppy Disk Drive Connector
PIN 1
FLOPPY
P4SDX
®
P4SDX IDE Connectors
NOTE: Orient the red markings
(usually zigzag) on the IDE
ribbon cable to PIN 1.
SEC_IDE
PIN 1
PRI_IDE
PIN 1
Pin 20 on each IDE connector is removed to match the covered hole on the
UltraDMA cable connector. This prevents incorrect orientation when you
connect the cables.