LBL Lighting Suspension canopy - Manual

1
Installation Instructions for
Suspension Canopy 1.1 CK001L_
980CK001L
Install the Canopy
GENERAL PRODUCT INFORMATION:
This product is suitable for indoor dry locations only.
This product can be dimmed with a standard incandescent dimmer.
1A
1 Turn the power to the electrical box off.
Make sure that the crossbar assembly is grounded in
accordance with local electrical codes.
Mount the crossbar assembly to the electrical box with the
two provided #8-32 screws.
2
3
1
#8-32
SCREW CROSSBAR
ASSEMBLY 2
3
3
1B
4 Loosen (Do Not Remove) the plastic set screw on the strain
relief.
STRAIN RELIEF
PLASTIC SET
SCREW
4
1C
5 Feed the cord through the strain relief and the canopy.
5
Adjust the fixture height (from bottom of the fixture shade to
top of the canopy) by moving the canopy up or down.
When the desired height is achieved, tighten the plastic set
screw on the strain relief.
Mark the cord underneath of the strain relief.
1D
6
5
STRAIN RELIEF
CANOPY
CORD
CORD
CANOPY
7
8
7
8
Suspension