LBL Lighting Fusion Jack Canopy 4" Round Flush LED - Manual

1
Installation Instructions for
Fusion Jack 4" Square and Round Flush Canopy 1.6 CK001_-FJ
980FSJ4RC
Install the Canopy
G P I : ENERAL RODUCT NFORMATION
This product is suitable for indoor dry locations only.
Minimum volume of the electrical box must be 6 cubic inches (98
cubic centimeters).
Model numbers ending in “-LED” or “-LED277” can be dimmed
with a low-voltage electronic dimmer, have a rated maximum output
of 60 watts, and are compatible with LED elements.
All other model numbers can be dimmed with a standard
incandescent dimmer, have a rated maximum output of 60 watts,
and are not compatible with LED elements.
Turn the power to the electrical box off.
In accordance with local electrical codes, ground the canopy
braided copper wire and the green transformer wire (if
attached).
Connect the white transformer wire to the neutral power line
wire with a wire nut.
Connect the black transformer wire to the hot power line
wire with a wire nut.
Place the transformer and all the wires inside the electrical
box. Use the adhesive pad to secure the transformer in the
electrical box.
Connect the canopy wires to the red transformer wires with
wire nuts.
Mount the canopy crossbar to the electrical box with the two
long #8-32 screws.
POWER
LINE WIRES
12 VOLT
TRANSFORMER
WIRES
#8-32 SCREW
CANOPY
CROSSBAR
CEILING
ELECTRICAL BOX
Fusion Jack
1A
1
2
3
4
5
6
7
4 6
2
7 7
6 3
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.