LBL Lighting Top-SI Coax - Manual

GENERAL PRODUCT INFORMATION:
This product is ETL listed and suitable only for indoor dry locations
and approved for use at any height above the finished floor.
CAUTION - RISK OF FIRE
This product requires installation by a qualified
electrician. Before installing be sure to read all
instructions and TURN THE POWER TO THE
ELECTRICAL BOX OFF.
Fusion Jack™
Installation Instructions for
Top-SI Coax 1.4 HS240_1B50FSJ
980FSJTOPSICP
Install the Lamp
1
Remove the three thumb screws.
LAMP
THUMB SCREW
NOTE: To reduce the risk of a burn or electric shock
during relamping, disconnect the power to the fixture.
NOTE: Use only your fingers and soft cloth to replace
the lamp.
Use MAX 50 Watt, Type Xelogen
(Xenon) Bi-Pin Lamp.
Carefully slide the diffuser glass completely onto the socket,
align the diffuser glass hole with the socket #4-40 set screw.
Slightly back out the #4-40 set screw with the 0.05 Allen
wrench to hold the diffuser glass in place.
#4-40 SET
SCREW
0.05 ALLEN
WRENCH
DIFFUSER GLASS
SOCKET
SOCKET
Push the lamp pins completely into the socket holes.
WARNING: RISK OF FIRE
Never replace a Xenon (Xelogen) lamp with a regular
Halogen lamp. A regular Halogen lamp requires a
protective glass shield.
1A
2
1B
1 3
4
1
2
1
1
3
4