LBL Lighting Dimensions - Manual

GENERAL PRODUCT INFORMATION:
This product is ETL listed and suitable only for indoor dry locations
and approved for use at any height above the finished floor.
CAUTION - RISK OF FIRE
This product requires installation by a qualified
electrician. Before installing be sure to read all
instructions and TURN THE POWER TO THE
ELECTRICAL BOX OFF.
Fusion Jack™
Installation Instructions for
Dimensions 1.4 HS337_
980FSJDMNSP
1
Install the Lamp and Disk
LAMP
SOCKET
Align and push the lamp pins completely into the socket holes.
With the small hole section of the crystal glass disk facing
towards lamp, place edge of the crystal glass disk into curved
section of accessory springs.
Use MAX 35 Watt MR11 Front Cover Halogen
Lamp .
CURVED
SECTION
LARGE HOLE
SECTION OF
THE CRYSTAL
GLASS DISK
ACCESSORY SPRINGS
CURVED SECTION
NOTE: The Crystal disk must be removed when relamping.
NOTE: To reduce the risk of a burn or electric shock
during relamping, disconnect the power to the fixture.
CAUTION: Do not install the crystal glass disk with the
large hole section of it facing towards the lamp, which will
cause the crystal glass disk eventually to fall out.
1A
1
2
1B
2
1
2
2
2
2