LBL Lighting Onyx Cone Accessory - Manual

Installation Instructions for
Onyx Cone Accessory 1.0 HAC481_
980ONYXCACC
Install the Onyx Cone Accessory
1
Push the Onyx Cone accessory base onto the grooved shade
holder.
GROOVED
SHADE HOLDER
ONYX CONE
ACCESSORY
ACCESSORY BASE
Push the lamp pins all the way into the socket holes.
MR16 LAMP
If the Monty accessory fits tight onto the fixture, then
carefully bend the grooved shade holder tabs in slightly
with the needlenose pliers. If it fits loose, then carefully
bend the grooved shade holder tabs out slightly with
the needlenose pliers.
GENERAL PRODUCT INFORMATION:
This product must be used with LBL Lighting systems only.
Use MAX 50 Watt MR16 Front Cover Halogen
Lamp.
Place the optional louver or glass lens into the Snap Louver
Lens Holder.
Place the MR16 lamp into the Snap Louver Lens Holder.
Press the tabs on both sides of the Snap Louver Lens Holder
against the MR16 lamp to keep it in the position.
MR16 LAMP LOUVER OR
GLASS LENS
TAB
SNAP LOUVER
LENS HOLDER
Accessories
GROOVED SHADE
HOLDER TAB
1
1A 1A 1A 1C
1A 1B
1
2
3
4
6
5
4
5
3 2
1A 1D
6