LBL Lighting Onyx Teardrop - Manual

1
Installation Instructions for
1.4
Install the Fixture
Loosen the M3 set screw on side of the (Do Not Remove)
onyx shade with the 1.5MM Allen wrench provided.
Remove the onyx shade.
M3 SET
SCREW
1.5MM ALLEN WRENCH
ONYX SHADE
BACKPLATE
CANOPY
M3 SET SCREW
1.5MM ALLEN WRENCH
Loosen the two M3 set screws on side of (Do Not Remove)
the canopy with the 1.5MM Allen wrench.
Remove the backplate.
6
4
G P I : ENERAL RODUCT NFORMATION
This product can mount to either a 4" square electrical box with
round plaster ring or an octagon electrical box.
This product is suitable for indoor dry locations only.
This product can be dimmed with a standard incandescent dimmer.
This instruction shows a typical installation.
This instruction is for the following models:
Onyx Cylinder Wall (HW176ON_2G60)
Onyx Dome Wall (HW177ON_2G60)
Onyx Teardrop Wall (HW178ON_2G60)
Onyx Wall HW17_ON_2G60
980ONYXW
1A 1B
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
Wall
1
3
3
2
4
1
4
2