LBL Lighting Showtime WD - Manual

1
Installation Instructions for
Showtime Wall (LED)
980SHOWTMWD
CAUTION - RISK OF FIRE
This product requires installation by a qualified
electrician. Before installing be sure to read all
instructions and TURN THE POWER TO THE
ELECTRICAL BOX OFF.
Install the Fixture
1.0
Wall
LW632_LED
GENERAL PRODUCT INFORMATION:
This product is suitable for damp locations.
This product can mount either to a 4” square electrical box with a
round plaster ring or an octagon electrical box.
This product can be dimmed with a low-voltage electronic dimmer.
This instruction shows a typical installation.
3 2
DRIVER
Connect the mounting plate ground wire to a suitable
ground according to local electrical codes.
Connect the white driver wire to the neutral power line
wire with a wire nut.
Connect the black driver wire to the hot power line wire
with a wire nut.
1
2
3
1A
1
Properly place all wire, wire nut connections, and the
driver inside the electrical box.
Attach the mounting plate to the electrical box using
the two #8-32 screws provided.
MOUNTING
PLATE
4
1B
ELECTRICAL BOX
#8-32 SCREW
1
1
5