LBL Lighting Juniper W - Manual

Installation Instructions for
Juniper Wall 1.3 JW230OPSC2D100
980JUNIPW
G P I : ENERAL RODUCT NFORMATION
This product can mount to either a 4" square electrical box with
round plaster ring or an octagon electrical box.
This product is suitable for damp locations.
This product can be dimmed with a standard incandescent dimmer.
Install the Fixture
Mount the crossbar assembly to the electrical box holes with
the two #8-32 screws provided.
CROSSBAR
ASSEMBLY
ELECTRICAL BOX HOLE
#8-32 SCREW
Feed the fixture wires through the mounting plate side hole.
Make sure that the crossbar is grounded in accordance with
local electrical codes.
Connect the fixture white wire to the neutral power line wire
with a wire nut.
Connect the fixture black wire to the hot power line wire with
a wire nut.
1
MOUNTING PLATE
FIXTURE
WIRES
1A
1
2
1
1B
2
3
4
1
4
5
5
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
Wall