LBL Lighting Derby WD - Manual

1
Installation Instructions for
Derby Wall (LED)
980DERBYWD
CAUTION - RISK OF FIRE
This product requires installation by a qualified
electrician. Before installing be sure to read all
instructions and TURN THE POWER TO THE
ELECTRICAL BOX OFF.
Install the Fixture
Remove the two mounting plate screws located on top
and the bottom of the fixture.
Remove the mounting plate.
1
1.0
WALL
1A
2
LW666_LED
1B
6 3 To gain access to the mounting plate holes, remove the
two thumb screw to temporarily loosen the plate
holding the LED lamp.
MOUNTING
PLATE
SCREW
MOUNTING
PLATE
MOUNTING
PLATE
SCREW
GENERAL PRODUCT INFORMATION:
This product is suitable for damp locations.
This product can mount either to a 4” square electrical box with a
round plaster ring or an octagon electrical box.
This product can be dimmed with a low-voltage electronic dimmer.
This instruction shows a typical installation.
THUMB SCREW
THUMB SCREW
LED PLATE