LBL Lighting Alban W LED - Manual

1
Installation Instructions for
Alban Bath (LED)
980ALBANWD
Install the Mounting Plate
G P I : ENERAL RODUCT NFORMATION
This product is suitable for damp locations.
This product can mount either to a 4” square electrical box with a
round plaster ring or an octagon electrical box.
This product may be dimmed with a low-voltage electronic dimmer.
This instruction shows a typical installation.
Remove the fixture screws located on the top and
bottom of the fixture base.
Remove the mounting plate from the fixture base.
Wall
1.0
B 824_LED A
1
1A
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
FIXTURE SCREW
1
MOUNTING
PLATE
FIXTURE SCREW
1
Attach the mounting plate to the electrical box using
the two #8-32 screws provided. 3
1B
2
MOUNTING
PLATE
3
#8-32 SCREW
3