LBL Lighting Dover WCF - Manual

Installation Instructions for
Dover Bath (Compact Fluorescent) 1.2 PW496OP_24L_HE
980DOVERBWCF
G P I : ENERAL RODUCT NFORMATION
This product can mount to either a 4" square electrical box with
round plaster ring or an octagon electrical box.
This product is suitable for damp locations.
This product can be mounted horizontally or vertically.
1
Hold the backplate up to the mounting plate. Line up the slots
in the backplate with the inner threaded holes in the mounting
plate.
Adjust the mounting plate as necessary so the backplate is
level when the threaded holes line up with the slots.
Fully tighten the short #8-32 screws to secure the mounting
plate in the desired position.
BACKPLATE
SLOT
SLOT
INNER THREADED HOLE
INNER THREADED HOLE
Install the Mounting Plate
If mounting vertically: Make sure the green ground screw
head faces out of the electrical box.
Make sure the green ground If mounting horizontally:
screw head faces into the electrical box.
Line up two long inner mounting plate slots with the two
electrical box holes and screw in the short #8-32 screws.
SHORT
SCREW
INNER
THREADED
HOLE
NOTE : These steps assume the threaded electrical box
holes are lined up horizontally. If the holes are lined up
vertically, follow the instructions opposite the desired
mounting direction.
VERTICAL HORIZONTAL
SHORT
SCREW LONG
INNER
SLOT GROUND
SCREW
LONG
INNER
SLOT GROUND
SCREW
(INSIDE)
Wall
1A 1B
1
2
3
4
5
1
2
1
2
3
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.