LBL Lighting Kett 3-Light - Manual

Installation Instructions for
Kett 3-Light Bath
980KETT3W
CAUTION - RISK OF FIRE
This product requires installation by a qualified
electrician. Before installing be sure to read all
instructions and TURN THE POWER TO THE
ELECTRICAL BOX OFF.
Install the Mounting Plate
GENERAL PRODUCT INFORMATION:
This product is suitable for damp locations.
This product can mount either to a 4” square electrical box with a
round plaster ring or an octagon electrical box.
This product can be dimmed with a standard incandescent dimmer.
This instruction shows a typical installation.
Wall
1.0
HW6693_2G
1
Remove the two set screws located on top of the fixture
base.
Remove the mounting plate by sliding it away from the
mounting studs then out of the fixture.
Attach the mounting plate to the electrical box using
the two #8-32 screws provided. 1
2
3
TOP VIEW
MOUNTING STUD
MOUNTING
PLATE
SET SCREW
1A
1 1
2 2
2
MOUNTING
PLATE
#8-32 SCREW
1B
3
3