LBL Lighting 2-Circuit MO 4" Round Canopy Dual Feed - Manual

Installation Instructions for
700MOPCEN_
1
4” Dual Flexible Power Feed Canopy
980MR2ADPFC
1.0 REMOTECNPY-DF-2C_
Loosen (Do Not Remove) the 3 set screws on each
strain relief.
Before cutting the center power feed wires to the
desired length, move the wire identification tags down
the wire.
Cut the end power feed wires to the desired length.
With a sharp knife cut 1" from the end of the wire web
and separate the wires 8" from each other on each side.
Push the power feed wires through the strain reliefs
leaving at least 6” of cord in the back of the canopy for
wire connections.
Re-tighten the set screws.
2
3
4
1
Install the Canopy
NOTE: Low voltage wires must be present in
electrical box before proceeding with these steps.
Refer to the instructions provided with the remote
transformer.
1A
Strip 1/2" off the wire ends.
Connect the center power feed wire marked "HOT1" to
electrical box marked "HOT1" with a wire nut.
Connect the center power feed wire marked "HOT2" to
electrical box wire marked "HOT2" with a wire nut.
Connect the power feed wire marked "COM" to electrical
box wire marked "COM" with a wire nut.
Repeat the connections for the second power feed wires
for the B side.
7
1B
Note : If mounting the canopy onto an octagonal
electrical box, first mount the provided universal
mounting plate before proceeding to this step.
8
5
NOTE: The Power Feed wires may be connected
directly to the transformer, Refer to the instructions
provided with the remote transformer for connection
details.
SET SCREW
STRAIN RELIEF
6
9
10
IDENTIFICATION
TAG
HOT B1
HOT B2
COM2
1
HOT A2
HOT A1
COM1
HOT B1
HOT B2
COM2
HOT A2
HOT A1
COM1
1
HOT A1
COM1
HOT A2
HOT B1
COM2
HOT B2
11
GENERAL PRODUCT INFORMATION:
This product is suitable for indoor dry locations only.
This product must be used with LBL Lighting 2-Circuit MonoRail
system only.
SPECIAL INSTALLATION