LBL Lighting 2-Circuit MO Direct Feed Standoff for Surf Xfmr - Manual

Installation Instructions for
1.0 HANGERDIRADJ-_1-2
980MR2SPSMT
1
G P I : ENERAL RODUCT NFORMATION
This product is suitable for indoor dry locations only.
This product is intended to be used with LBL Surface Mount
Transformers and 2-Circuit Monorail system only.
Telescoping Rigid Standoff for Surface Mount Transformers
Install the Rigid Standoffs
2-Circuit Monorail
ANCHOR
Select a location on the ceiling where the 2-Circuit Monorail is
to be mounted.
One way of marking the standoff locations on the ceiling is to
lay the 2-Circuit Monorail on the floor underneath of the
selected location and by using a plumb bob pointing on the
center of the 2-Circuit Monorail, mark the points on the
ceiling.
The other way is to hold the 2-Circuit Monorail directly
against the ceiling and mark the standoff points on the ceiling.
Tap the anchors at the marked points up to the threaded
portion with a hammer.
Screw the anchors in the rest of the way with a Phillips
screwdriver.
Insert the #8 screw into the threaded nipple and washer.
Tighten the #8 screw completely into the anchor to secure the
washer and threaded nipple.
Repeat step 4 through 6 for the remaining standoffs.
ANCHOR
WASHER
#8 SCREW
THREADED NIPPLE
CAUTION: This standoff is not applicable with
vaulted ceilings.
CEILING
1B 1A
1
2
3
4
6
5
4
6
1B 1A
5
7
1B 1C