LBL Lighting Fusion Jack Canopy 5 Light Round LED User Manual
3,5, & 7 round fusion jack canopy, Install the canopy, Installation instructions for
Installation Instructions for
3,5, & 7 Round Fusion Jack Canopy
980FSJLPRC
1
Install the Canopy
#8-32 SCREW
MOUNTING PLATE
CANOPY HOUSING
Remove the #8-32 screws on the sides of the canopy housing.
Lift the mounting plate from the canopy housing.
MOUNTING PLATE
With a hammer tap the anchors at the marked points into the
ceiling up to the threaded portion.
Screw the anchors in the rest of the way with a Phillips
screwdriver.
ANCHOR
ANCHOR
Feed the power line wires through the mounting plate
center hole.
Line up the two mounting plate slots with the electrical box
holes and use the two provided #8-32 screws to mount it to
the electrical box.
#8-32 SCREW
Align the mounting plate holes with the electrical box holes
and mark four points onto the ceiling through the mounting
holes.
7
7
MOUNTING
PLATE HOLE
G
P
I
:
ENERAL
RODUCT NFORMATION
This product is suitable for indoor dry locations only.
This product can be dimmed with a standard incandescent dimmer.
LED versions are dimmable with a low-voltage electronic dimmer.
This instruction is for the following models:
7 Port Round Canopy (CK007B-FJ-_)
5 Port Round Canopy (CK005B-FJ-_)
3 Port Round Canopy (CK003B-FJ-_)
3 Port Round Canopy (CK003D-_-FJ)
Fusion Jack
1.3
CK00_B-FJ-_, CK003D-_-FJ
1A
2
1
1
1
1B
1
2
3
1C
4
5
5
5
4
5
6
7
1D
6
7
7