LBL Lighting MO 2.75" Round Canopy - Manual

Installation Instructions for
700MOPCEN_
1
G P I : ENERAL RODUCT NFORMATION
This product is suitable for indoor dry locations only.
This product must be used with LBL Lighting MonoRail
system only.
MONORAIL
2” Flexible Power Feed Canopy
980MRLA2PFC
1.2 REMOTECNPY-_2
Loosen the set screws on each strain (Do Not Remove)
relief. Dual Feed will have two set screws on each strain
relief.
Cut the end power feed wires to the desired length.
With a sharp knife cut 1" from the end of the wire web
and separate the wires 8" from each other.
Push the power feed wires through the strain reliefs
leaving at least 6” of cord in the back of the canopy for
wire connections.
Re-tighten the set screws.
2
3
4
1
Install the Canopy
NOTE: The 2” Electrical Box and Low voltage
wires must be present in electrical box before
proceeding with these steps. Refer to the
instructions provided with electrical box and
remote transformer.
1A
2A
Strip 1/2" off the wire ends and connect them to the low
voltage wires with the provided wire nuts. 6
SET SCREW 1
2A
STRAIN RELIEF
5
NOTE: The Power Feed wires may be connected
directly to the transformer, Refer to the
instructions provided with the remote
transformer for connection details.
1B
6 6
2” ELECTRICAL
BOX