LBL Lighting LED Illum MO Generator Single - Manual

Installation Instructions for
LED Generator (Single) 1.1 LEDMRLE_SC
980MRLSGEN-LED
G P I : ENERAL RODUCT NFORMATION
1
Connecting the LED Generator to
the LED-Illuminated Monorail
CONDUCTIVE CONNECTORS
LED-ILLUMINATED
MONORAIL
1.6 MM ALLEN WRENCH
M3 SET
SCREW
Feed the conductive connectors completely into the LED-
Illuminated Monorail.
Push the LED generator completely onto the other side of the
conductive connectors.
Tighten each conductive connector M3 set screws with the
provided 1.6 MM Allen wrench by inserting the 1.6 MM Allen
wrench through the LED generator hole to access the set
screw. Make sure that the set screw connection is tight to
avoid heat build up and corrosion.
LED GENERATOR
SAVE THESE INSTRUCTIONS!
7400 Linder Ave, Skokie, IL 60077
800.323.3226 - 847.626.6300
www.lbllighting.com
© 2014 LBL Lighting.All rights reserved.The "LBL Lighting" graphic is a
registered trademark of LBL Lighting. LBL Lighting reserves the right to
change specifications for product improvements without notification.
A Generation Brands Company A Generation Brands Company
1
2
1A 1A
2
3
3
1
LED-Illuminated Monorail
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.