LBL Lighting MO 4" Round Flexible End Feed Canopy - Manual

Installation Instructions for
End Power Feed
980MRLENDP
1
1.0 REMOTECNPY-FLEX-_
G P I : ENERAL RODUCT NFORMATION
This product is suitable for dry locations only.
This product must be used only with LBL Lighting Monorail systems.
Mount the crossbar to the electrical box with the two screws
provided.
Pull the low voltage wires out of electrical box for power
connection.
NOTE: Low voltage wires must be present in electrical
box before proceeding with these steps. Refer to the
instructions provided with the remote transformer.
SCREW
LOW VOLTAGE WIRES
COMING FROM THE
REMOTE TRANSFORMER
CROSSBAR
Installation Option 1:
Mount Canopy to Electrical Box
BUSHING
Cut the end power feed wires to the desired length.
With a sharp knife cut 1" from the end of the wire web and
separate the wires 8" from each other.
Push the power feed wires through the canopy bushings and
slide the canopy down the wires.
Strip 1/2" off the wire ends and connect them to the electrical
box low voltage wires with the provided wire nuts.
Place the wire nut connections into the electrical box.
Monorail
1A 1A
1
2
3
2
1
1A 1B
5
6 6
4
5
6
7