LBL Lighting MO Direct Feed Standoff for Surf Xfmr - Manual

Installation Instructions for
Telescoping Rigid Standoff for Surface Mount Transformers 1.1 HANGERDIRADJ_1
980MRLSPSMT
1
Install the Rigid Standoffs
ANCHOR
G P I : ENERAL RODUCT NFORMATION
This product is suitable for indoor dry locations only.
This product is intended to be used with LBL surface mount
transformers and Monorail system only.
Select a location on the ceiling where the Monorail is to be
mounted.
One way of marking the standoff locations on the ceiling is to
lay the Monorail on the floor underneath of the selected
location and by using a plumb bob pointing on the center of
the Monorail, mark the points on the ceiling.
The other way is to hold the Monorail directly against the
ceiling and mark the standoff points on the ceiling.
Tap the anchors at the marked points up to the threaded
portion with a hammer.
Insert the #8 screw into the threaded nipple and washer.
Tighten the #8 screw completely into the anchor to secure the
washer and threaded nipple.
Repeat step 4 through 6 for the remaining standoffs.
CAUTION: This standoff is not applicable with
vaulted ceilings.
CEILING
Screw the anchors in the rest of the way with a Phillips
screwdriver.
ANCHOR
WASHER
#8 SCREW
THREADED NIPPLE
Monorail
1B 1A
1
2
3
4 6
5
4
6
1B 1A
5
7
1B 1C