LBL Lighting T-Grid Clip User Manual
T-grid clip, Install the t-grid clip, Install the rigid standoff
Installation Instructions for
T-Grid Clip
1.1
CLIP-TB/MONO-_
980MRLTGRID
1
G
P
I
:
ENERAL
RODUCT NFORMATION
This product is suitable for indoor dry locations only.
Select the locations on the grids where the standoffs will be
mounted.
Push the T-Grid clip flat section against the grid. Rotate the
T-Grid clip until the tabs on the T-Grid clip snap behind
the grid.
Install the T-Grid Clip
TAB
GRID
SUPPORT POST
Loosen
the M4 set screw on the support
(Do Not Remove)
post with the 2 MM Allen wrench provided to remove the
support post.
2 MM ALLEN
WRENCH
M4 SET
SCREW
Install the Rigid Standoff
THREADED NIPPLE
Screw the threaded nipple to the threaded stud.
THREADED STUD
THREADED NIPPLE
Monorail
1A
1A
1A
2A
1
1
2
2
SUPPORT POST
Screw the support post completely to the threaded nipple.
1A
1B
3
3
1A
2B
2
1
2