Acoustic Research ARWH2 - Manual (Page 6)

C ONNECTIONS
6
C
ONNECTING THE
T
RANSMITTER
The ARWH2 requires no software to setup, so you can start using the unit right
away.
1. Plug the transmitter USB plug into an available USB port on your computer.
2. Press the Power button on the receiver to turn it on. The indicator comes on
and turns blue when the receiver and transmitter are linked.
Note: The transmitter and receiver are pre-linked for communication at the
factory, but if the indicator on the receiver fl ashes blue when you turn it on, the
units may need to be linked. To link them, press and hold the receiver’s Power
button and the transmitter’s LINK button for 3 seconds. The indicator turns
solid blue when both units are linked.
3. Plug your headphones or the included earbuds into the headphone jack on
the receiver.
4. Open your music or communication software on your computer, and your
ARWH2 is now ready to use.
Note: The headphone jack on the receiver uses a 3.5mm standard headphone
plug, so if you want to use a headset or earpiece from your cell phone, you will
need to use an adapter.
Power button on the
receiver
LINK button on the transmitter
Connecting the transmitter to a laptop