Agilent Technologies E4438C - Manual (Page 90)

Performance Tests
Performance Test Records
3-42
Performance Test Records
The test records at the end of this chapter are provided as masters for you to photocopy.
Table 3-2 provides a place to record the equipment used while Table 3-3 and Table 3-4 are provided for
recording the results of manual tests:
• “Timebase Aging Rate (Manual Test - Option UNJ, Option 506, or Option 1E5 Only)” on page 3-24
• “Phase Noise and Residual FM (Manual Test - Option UNJ or Option 506 Only)” on page 3-35
Where applicable, use the Service Support Software to print out a test record of the results obtained from the
automated performance tests.
Table 3-2 Agilent E4438C ESG Vector Signal Generator Performance Test Record
Test Equipment Used Model Number Trace Number Cal Due Date
Model ___________________ Report Number __________________ Date___________
Arbitrary Waveform Generator
Attenuator (10 dB)
Audio Analyzer
Frequency Counter
Function Generator
Low Noise Amp (0.1–10 MHz)
Low Noise Amp (0.03–2 GHz)
Measuring Receiver
Mixer (0.5–9 GHz)
Mixer (0.001–2.8 GHz)
Power Meter
Power Sensor
Primary Frequency Standard
Signal Generator
Spectrum Analyzer
Vector Signal Analyzer
W-CDMA Spectrum Analyzer
______________
______________
______________
______________
______________
______________
______________
______________
______________
______________
______________
______________
______________
______________
______________
______________
______________
______________
______________
______________
______________
______________
______________
______________
______________
______________
______________
______________
______________
______________
______________
______________
______________
______________
______________
______________
______________
______________
______________
______________
______________
______________
______________
______________
______________
______________
______________
______________
______________
______________
______________