Allied Telesis AT-2746FX - Manual (Page 96)

Chapter 3: Microsoft Windows 2000, 2003, and XP
96
6. Click OK to close the Internet Protocol (TCP/IP) Properties window.
7. Click OK to close the Local Area Connection Properties window.
This completes the procedure for configuring the IP address and
subnet mask of a network adapter card.
Configuring
Additional
Network Adapter
Card Settings
This procedure explains how to change these parameters on a network
adapter card:
ˆ Port speed and duplex mode
ˆ Magic packet
ˆ QoS tagging
ˆ VLAN ID
ˆ Locally administered MAC address
ˆ Load balancing mode and fail-over protection
Note
For a dual port adapter Allied Telesyn recommends connecting the
appropriate port on the adapter to the network before performing this
procedure. Additionally, check to be sure that the remote device to
which the port on the adapter is connected is powered ON.
Caution
If you are planning to use the load balancing or fail-over protection
feature of the LBFO driver, do not connect both adapters to the
network at the same time until after you have configured the feature.
To configure these parameters, perform the following procedure:
1. From the desktop, right-click My Computer, then select Properties.