American Dynamics AD912A User Manual
Page 7
6.
Connector to the video output of a VCR or another monitor (for loop-through
connection) or to a video camera.
Loop-through output of the VIDEO IN connector . Connector the video input of
another monitor or a VCR.
7.
Set to EIA for EIA standard.
Set to CCIR for CCIR standard.
8.
To adjust this control for the vertical size of the picture.
9.
To adjust this control for the vertical linearity of the picture.
VIDEO IN / OUT CONNECTOR
SCAN MODE SELECTOR(EIA
CCIR)
V-HEIGHT CONTROL
V-LIN. CONTROL
Note
Caution
: The impedance is automatically set to 75 ohm by the input of a signal on the
input connector while operating in a single connection mode. However, if a cable
is connected to the output connector, the connection is placed into the open
status by the multiple connection and high impedance automatically selected.
: Do not leave an unused cable connected to the monitor. If a single cable is
used, then it must be connected to the input connector for the 75 ohm auto-
termination selector to function properly.
BACK 9"
7
6
9
8
7
6
9
8
- 7 -
12"