Pitco Frialator 26 Gas Fryer - Manual (Page 8)

Model 20, 24, 26 and 34 INSTALLATION
8 L20-078 Rev. 6 (05/11)
c. When properly installed the angled section of the heat deflector will extend over the flue
opening to redirect the heat. It SHOULD NOT cover the flue opening. Never allow
anything to block the flue opening; this will cause the appliance to over heat and inhibit
proper combustion, which could produce dangerous gases
1.8 SPLASH BACK
a. Lift the splash back assembly and place it over the opening at the back of the tank.
Make sure that the front of the splash back faces forward.
b. Using the four supplied countersink screws, attach the splash back to the cabinet
sides.
1.9 DRAIN BOARD
While the drain board is being held in place, slide the pivot rod through the hose in the bottom of
the drain board. The end of the rod should locate in the hole in the splash back. The front end is
attached to the top of the tank using the bolt and washer provided.