Vaddio DomeVIEW Indoor Pendant Mount - Manual (Page 7)

Vaddio DomeVIEW Indoor Pendant Mount Dome Installation and User Guide - Document 341-444 Rev. C
Page 7 of 12
CAMERA CONTROL
For the DomeVIEW 50iR Indoor Pendant Mount Dome and DomeVIEW 70 PTZ Indoor Pendant Mount
Dome Systems, the RS-232 control programming information is in the technical manuals for the Sony EVI-
D70 (VISCA control protocol) and Canon VC-C50iR PTZ which can be found on the Vaddio website
(
www.vaddio.com ) under the TechNotes tab and under the PTZ Camera product grouping. Control system
manufacturers’ also have programs readily available for these cameras to be used with their control systems
(i.e. Crestron® and AMX®). Please contact those companies for the demo programs and for modifying or
debugging of the programs that they provide to you. They will be more familiar with their bugs than we will.
Both the DomeVIEW 50iR Indoor Pendant and the DomeVIEW 70 Indoor Pendant are shipped with IR
remote controllers for camera control. The camera base with the IR window is recessed inside the dome
enclosure and the acceptance angle of the IR control signaling is affected. The angle of acceptance for the
IR remote control is narrower and more directional. Please take this into account when controlling the
cameras with an IR remote.
RS-232 OUT to
next camera for
daisy chain
control
RS-232 on
Cat. 5e
1-1/2” NPT Pipe
(Not supplied)
Figure 10:
EZCamera Cable Shoe for the DomeVIEW 70 shows RJ-
45 connections for Power/Video, RS-232 IN and RS-232
OUT on the top of the Shoe (upper image). The back of
the Shoe (lower image) shows the connector labeling.
See Appendix A for pin-out information.
POWER
VIDEO RS-232
IN RS-232
OUT
Figure 11: Basic wiring diagram for the DomeVIEW Indoor Pendant Mount.
For cabling distances using the standard and optional power supplies for the
DomeVIEW 50iR and 70, see the previous page for additional information.