White balance, Zoom/focus, 15 basic functions – Vaddio Sony EVI-HD1 PTZ Camera User Manual
Page 15
15
Basic Functions
White Balance
Mode
Power On
Power Off
1)
IFC
2)
Initializing
3)
White balance mode
During displaying
Memory Recall
Command
Auto
Indoor
Outdoor
One Push
Manual
the menu
CAM_WB Auto/Indoor/Outdoor/
OnePhshWB/Manual
ЧЧ
Ч
aaaaa
Ч
4)
Ч
CAM_WB One Push Trigger
ЧЧ
ЧЧЧЧ
a
5)
ЧЧ
4)
Ч
CAM_WB R(B) Gain
Reset/Up/Down/Direct
ЧЧ
ЧЧЧЧЧ
a
Ч
4)
Ч
1)
DC power is being supplied, but the camera has been turned off by a VISCA command.
2)
The period from the time IF Clear is sent, until the Reply Packet is returned.
3)
The period from the time DC power is turned on or the camera is turned on via a VISCA command, and the camera subsequently fi
nishes the pan/tilt reset operation and stops at the Home position, until the
video signal is output. Or the period from the time the CAM Power ON command is sent, until Completion is returned.
4)
The camera is not limited in operation due to the menus. But the camera follows the operational restrictions of the current m
ode during IFC executing/initializing/white balance mode operation.
5)
Commands are ignored during a One Push AWB operation.
Zoom/Focus
Mode
Power On
Power Off
1)
IFC
2)
Initializing
3)
Zoom Direct
Focus Direct
AF ON
During displaying
Memory Recall
Command
the menu
CAM_Zoom Tele/Wide/Stop [VISCA]
ЧЧЧЧ
aa
Ч
4)
Ч
CAM_Zoom Tele/Wide/Stop [RC]
ЧЧЧЧ
aa
Ч
4)
Ч
CAM_Zoom Direct
×××
aaa
Ч
4)
Ч
D-Zoom Limit
ЧЧЧЧ
aa
Ч
4)
Ч
CAM_Focus Far/Near/Stop [VISCA]
×××
a
ЧЧ
Ч
4)
Ч
CAM_Focus Far/Near/Stop [RC]
×××
a
ЧЧ
Ч
4)
Ч
CAM_Focus Direct
×××
aa
ЧЧ
4)
Ч
CAM_Focus Mode (Auto/Manual)
×××
a
×
a
Ч
4)
Ч
CAM_Focus One Push Trigger
×××
a
ЧЧ
Ч
4)
Ч
CAM_Focus Infinity
×××
a
×
a
Ч
4)
Ч
CAM_Focus Near Limit
×××
a
×
a
Ч
4)
Ч
1)
DC power is being supplied, but the camera has been turned off by a VISCA command.
2)
The period from the time IF Clear is sent, until the Reply Packet is returned.
3)
The period from the time DC power is turned on or the camera is turned on via a VISCA command, and the camera subsequently fi
nishes the pan/tilt reset operation and stops at the Home position, until the
video signal is output. Or the period from the time the CAM Power ON command is sent, until Completion is returned.
4)
The camera is not limited in operation due to the menus. But the camera follows the operational restrictions of the current m
ode while the camera is receiving the command in each mode.