Vaddio Wall Mount and Pole Mount - Manual

Camera and Electronic Products for Integrators
2006 Vaddio - All Rights Reserved. Reproduction in whole or in part without written permission is prohibited.
Specifications and pricing subject to change. Vaddio and DomeVIEW are registered trademarks of Vaddio. Document 341-446, Page 1 of 2
Installation and User Guide
Curved Wall Mount and Pole Mount Kit
For DomeVIEW™ Indoor and Outdoor Pendant Mount Domes
Wall Mount Kit 998-9300-000
Wall Mount with Pole Mount Kit 998-9300-001
Installation (Curved Wall Mount 998-9300-000 Only)
1. Carefully unpack box, inspect contents for damage and verify that all components are included.
2. Attach the mount to the wall, using the appropriate fasteners (not included) for the mounting surface.
3. Route power and video leads through mount by pulling enough length to reach into the housing.
4. Attach the dome 1-½” NPT fitting to the wall mount and lock into place with the provided 1-½” NPT lock nut.
5. Refer to the housing instruction sheet to complete the installation (see Figure 1).
Installation (Curved Wall Mount and Pole Mount Kit - 998-9300-001)
1. Carefully unpack box, inspect contents for damage and verify that all components are included.
2. Feed the stainless bands through the slots and attach the mount to the pole firmly by tightening the bands with a
screwdriver (see Figure 2).
3. Install the Curved Wall Mount by attaching the wall mount to the Pole Mount with the bolts provided. Make sure
that the mount is level and tighten all four (4) bolts firmly. Run the cabling, pulling enough length through to
reach into the housing without strain.
4. Seal the wire passage with silicone sealant (not included). Provide a drip loop if the cable entry is from the top.
5. Attach the dome 1-½” NPT fitting to the wall mount and lock into place with the provided 1-½” NPT lock nut.
6. Refer to the housing instruction sheet to complete the installation.
Figure 1:
Curved Wall Mount for Indoor and Outdoor Pendant Domes
Vaddio Part # 998-9300-000
Curved Wall Mount comes with:
One (1) Curved Wall Mount
(No other screws or accessories are included)
Dimensions:
Mounting Plate (H x W) - 7.5” (19.05cm) x 4.5” (11.43cm)
Distance from Wall - 10.5” (26.67cm) to center of pipe
Height - 9.5” (24.13cm)
Figure 2:
Curved Wall Mount and Pole
Mount Adapter for Indoor and
Outdoor Pendant Domes
Vaddio Part # 998-9300-001
Pole Mount Kit comes with:
One (1) Pole Mount Adapter Plate
Four (4) Stainless Steel Bolts
Two (2) Steel bands with clamps
Dimensions:
Mounting Plate (H x W) – 7.5”
(19.05cm) x 5.25” (13.34cm)
Back Flange - 2” (5.08cm) Deep