Martin Universal Design 91-6008 - Manual (Page 3)

PAGE 3
P 7.
9. 10.
8.
If properly assembled, the backrest plate (P) and
backrest support bar (D) should look like the above
photograph. Once this is achieved move on to Step 8.
D
Continue by taking the Backrest Cover (I) and placing it
into position onto the backside of the backrest plate (P).
NOTE: The metal backrest plate should lay flat against
the backrest cover (I).
9.
The Backrest Support bar should now look like the
above photograph. This Backrest Support Bar is now
ready to have the backrest (G) attached to it.
NOTE: Backrest Support should be attached to seat as
displayed in Step 4.
D
I
D
P
Attach Backrest Support assembly (Parts D, I & P) to
upholstered back using the [2] black screws provided
making sure the screw holes in backrest cover (I) line up
with the screw holes in the upholstered back.
Tighten screws securely.
4444 Lawton Avenue, Detroit MI 48208 USA Tel:(313)895-0700 •
Fax:(313)895-0709
E-mail: [email protected]
Visit us at:
www.MartinUniversalDesign.com
IMPORTANT
If you have difficulty assembling your chair or need
customer service assistance. Please call: Martin Universal
Design, Inc. Customer Service Hot Line at
1-800-366-7337. If you need additional parts, it is not
necessary to contact your dealer, our Customer Service
Rep. will forward them to you immediately.