Front panel – Australian Monitor IN400 User Manual
Page 4
PAGE 4
IN400 INSTALLATION AND OPERATION MANUAL
FRONT PANEL
3
1
5
7
4
2
6
8
1
MASTER VOLUME
This pot controls the audio output level.
2
MASTER VOLUME LEDS
These LED’s indicate the position of the volume control. They do not indicate the
strength of the signal.
3
SOURCE SELECT SWITCHES
These switches select the input that is routed to the audio and video outputs.
4
SOURCE SELECT LEDS
The LED above the switch indicates when the channel is being routed to the
outputs.
LED State
1. A solid LED means that both audio and video from that source is routed to the
respective outputs.
2. A long fl asing LED means that audio from that source is routed to the audio
output.
3. A short fl asing LED means that video from that source is routed to the video
output.
Source audio and video splitting is achievable through RS485. See the section on
Communications on page 6 for more information.
5
POWER SWITCH
This switch switches the unit on.
6
POWER ON LED
This indicates the unit is on.
7
IR SENSOR
This is the sensor used for IR control. A hand held remote control is supplied with
the IN400. Line of sight is required for the remote control to work.
8
COMMS LED
This LED indicates when data is sent or revceived via IR or RS485.