Vollrath E257A - Manual (Page 10)

4
Figure 6
Warning Label Locations - E157A
IMPORTANT NOTICE TO OPERATOR
BEFORE INSTALLING EQUIPMENT, READ THE OWNER'S MANUAL CAREFULLY. TAKE NOTE OF ALL INSTRUCTIONS AND CAUTION
DECALS ON THIS EQUIPMENT.
GO OVER THE MANUAL THOROUGHLY AND POINT OUT ALL DECALS TO YOUR EMPLOYEES, SO THEY UNDERSTAND HOW TO SAFELY
OPERATE THIS EQUIPMENT.
DO NOT REMOVE, DEFACE, OR PAINT OVER ANY DECALS. THEY ARE THERE FOR YOUR SAFETY.
CAUTION
THIS DEVICE MUST BE PLUGGED INTO A PROPERLY GROUNDED
RECEPTACLE TO PREVENT ELECTRICAL SHOCK HAZARD.
TAMPERING WITH THE PLUG OR USING VOLTAGES OTHER THAN
THE SPECIFICATIONS ON I.D. PLATE WILL VOID YOUR WARRANTY.
REFER TO OWNER'S MANUAL FOR INSTALLATION
INSTRUCTIONS.
723529
„ „ „ „ „
„ „ „ „ „
(Behind Sani-tray)
HAZARDOUS MOVING PARTS
DO NOT OPERATE UNIT WITH OUTER
COVERING REMOVED.
S24107
CAUTION
THIS DEVICE MUST BE PLUGGED INTO
A GROUNDED RECEPTACLE TO
PREVENT SHOCK HAZARD.
324113
CAUTION
(Behind Sani-tray)
DANGER
ELECTRONIC SHOCK HAZARD
DISCONNECT FROM THE SOUCE OF
ELECTRICAL SUPPLY IN BUILDING
BEFORE SERICING UNIT
321105